Surface texturing of cutting inserts for turning of aluminium – Study of cutting forces, wear, chip formation and tool-chip contact

An article created on 2026-10-20 14:05:31

#	Наименование новости	Информативность	Дата публикации
1	Experimental Assessment of Cryogenic Surface Grinding of AISI 4140H Steel	14.65	20-10-2026
2	Improvement of Biopsy Needle Inner Surface Quality Using Magnetic Abrasive Jet Machining: A CFD-Supported Experimental Study	19.09	20-10-2026
3	Surface Roughness Evolution and Tool-Wear Mechanisms in Prolonged Milling of Ti6Al4V ELI under Sunflower-Oil and MoS₂-Enhanced MQL Environments	25.16	19-08-2026
4	Deep Learning-Driven Multi-Objective Optimization of Surface Finish and Tool Wear in CNC Dry Turning	25	19-08-2026
5	Numerical simulation-driven design and cutting-force-validated evaluation of a large-diameter BTA trepanning tool for SS304L stainless steel	32.73	20-10-2026
6	A Leakage-Safe, Interpretable Machine Learning Baseline for CNC Tool Wear Classification: Reproducibility Lessons from the UC Berkeley Milling Dataset	18	20-10-2026
7	The Effect of Fe Content on the Microstructure and Properties of Cast Al7Si0.3Mg Alloy	15.73	10-08-2026
8	Physics-Informed Neural Network with Adaptive Path Compensation for Intelligent Corner Error Prediction in Wire Electrical Discharge Machining	18.7	21-10-2026
9	Boundary Layer Relaxation Effects with Actuator Line Turbulence Correction	16.67	21-10-2026
10	Carry Incentives and Net Warrant Accumulation: Evidence from SHFE Aluminum	16.25	20-10-2026

Классификация: Наука. Схожих патентов: 0. Схожих новостей: 10. Тональность: 0. Информативность: 14.63. Источник: www.researchsquare.com.

Найдите то, что Вас интересует